This afternoon, I went to LOWERS.
There's a bit of wind and the waves are the smallest they've been in weeks.
That said, there was a set of this size.
When you look into Lost's surfboard factory,
The AKU machine was not working properly and was undergoing maintenance.
If you neglect to clean the machine, foam powder will get clogged, and if you do not oil it regularly,
This will make it harder to move and make it difficult to cut the foam accurately.
This is what the AKU machine looks like from the back, opposite to the usual.
In addition to AKU, LOST has another machine,
This DSD machine is coming in handy today.
However, the DSD machine can only cut the center stringer.
This is because the machine fixes and cuts the center stringer like this.
Each model is stored in front of Mayhem's desk.
This is a data floppy disk for the DSD machine.
Therefore, these upcoming parallel FLEX models could not be cut.
By the evening, I was relieved to hear that the AKU machine had been restored.