What if the sticker on my XTR board bulges?
The vent holes on the XTR board allow you to vent when the board gets warm.
This allows the gas generated from the XTR foam to escape.
If you put a sticker over the hole and block the vent hole,
The sticker may bulge out,
In such cases, just pierce it with a needle.
If you make a hole in the sticker, the bulge will flatten out.
This will prevent the sticker from re-inflating.
If you have an XTR board and the sticker has bulged,
It's very easy, so please give it a try.
Basically, even if you block the vent hole with a sticker,
There are many other vent holes in the board that allow the gas to escape.
Don't worry, there's nothing wrong with the board.
