Must-see! Special technique #1! "How to easily remove FCSII fins!"
Hard
My hands hurt!
It's hard to get!
And so,
If you have trouble removing your FCSII fins, we'll teach you Nishii's secret technique.
The things I always have when surfing are:
"Leash cord" and "towel."
Simply put, you release it using a "leash cord."
Now, I'll teach you how to do it in three steps.
1. First, lay a folded towel down and hold the snowboard down with one foot.
2. Use your non-dominant hand to release the FCS II fin.
Please hold it lightly so that it doesn't fly away.
3. Then, make a loop by rolling up the ankle part of the "leash cord."
As shown in the photo, hook the tip of the "FCS II fin" with your dominant hand,
Gradually increase the force and pull to remove.
Here's a trick to remove it,
It's best to hold the ankle part and pull rather than just holding the cord.
Even quad fins with many fins can be removed in an instant.
After doing this many times, Nishii was able to hold the fin between his toes.
If you do, you will be an expert in removing FCS II fins.
*Note*
Please place your board on carpet, grass, or sand to avoid damaging it. If you absolutely must do it on hard ground, such as an asphalt or gravel parking lot, be sure to lay down a board case, wetsuit, or towel to prevent damage to the board. Also, be careful not to let the fins fly off and damage the board!
I think after seeing this, you will love FCSII fins even more.
The only board tuning accessory that can change the performance of your board right now.
Purchase FCSII fins here.
