We will explain how to properly apply Nishii's summer version of "FU WAX".

We will explain how to properly apply Nishii's summer version of "FU WAX". "FU WAX" is a small factory in Brazil. It's a secret recipe that only FU can make. It is 100% handmade, carefully mixed and produced over time and with great care. They are shipped to Japan and sold for about three months. Now that the secret of 3D grip performance has been revealed, It is no exaggeration to say that almost everyone Used by WSL and WQS surfers, For Japanese users who are not willing to compromise on surfing goods We will explain how to properly apply the summer version of ``FU WAX'' that you are using. There are three types of "FU WAX" available. ＊BASE *TROPICAL *WARM These are the three. *To create the base, first apply "BASE". The Nishii method involves carefully applying the FU WAX horizontally, pressing it down about 20-25cm, as if you were painting a picture, so that no areas are left uncoated . Once the entire board is coated, apply another 20-25cm of FU WAX vertically in the same way . If you have been riding a POLY board for a long time, there will be dents and dents, so if you try to smooth out the dents with FU WAX , there will be areas that are not covered, so you should apply it to the edges a little. It's a good idea to make sure that the ``FU WAX'' penetrates into the recesses as well . This is the amount of "BASE" used after applying it vertically and horizontally. Apply approximately 1/4 to 1/5 of the amount to a standard shortboard. This is just the right amount. *As a mid-coat, Apply " TROPICAL " on top of "BASE" . Apply it more thinly than when you applied "BASE", carefully and without leaving any gaps, as if you were coloring a picture, and apply it in the same way, pressing about 20-25cm vertically and 20-25cm horizontally. Apply the middle coat at a rate of approximately 1/6 to 1/8. This is just the right amount. *As a top coat, Apply a very thin layer of `` WARM '' in the same way. Apply the paint thinly and carefully in both vertical and horizontal directions without leaving any areas uncoated to achieve a perfect grip. Apply about 1/8 to 1/10 of the top coat. This is just the right amount. We recommend a mix of all three! Unlike previous waxes that only grip horizontally, FU WAX There's no need to create ugly bumps and grip left and right. "FU WAX" is a "3D surf wax" that grips and tucks not only left and right, but also upwards, so once it's applied, your car won't slip. Be sure to apply it carefully, thinly and skillfully, so that no areas are missed. http://www.luvsurf.co.jp/store/11847/ Purchase "FU WAX" here!